Bei mir tut sich bei Page-UP gar nichts...,
Ich glaube aber auch, dass ich die File nicht alle richtig konfiguriert habe - ich bin bei den Anweisungen auf GitHub nicht ganz durchgestiegen.
Ich habe nur "make roms" gemacht. Und später habe ich das automatisch erstellte SD-Image durch das hier aus dem Forum ersetzt.
Muss man noch etwas anderes hineinkopieren? Muss man noch etwas umbenennen?
ich bekommen nämlich beim Start auch ein paar komische Meldungen:
Code
- FILE: @mega65-default.cfg cannot be open, tried path(s): /home/marcel/.local/share/xemu-lgb/mega65/mega65-default.cfg
- CFG: Default config file @mega65-default.cfg cannot be used
- INSTALLER: not activated.
- WARNING: *** NEW M65 HACK MODE ACTIVATED ***
- ...
- DCARD: configuring F011 FDC with have_disk=0, can_write=1
- FILE: file @mega65.img opened as /home/marcel/.local/share/xemu-lgb/mega65/mega65.img with base mode-set as fd=13
- SDCARD: card init done, size=971 Mbytes, SDHC flag = 0
- DMA: 'hack' (preliminary!! support for new-style M65 DMA) status: **ENABLED**
- DMA: initializing DMA engine for chip revision 0, dyn_mode=YES(M65-aware), modulo_support=DISABLED.
- ...
- SDCARD: warning, unaligned read access: offset = 2
- SDCARD: D81: mount register request @ $D68B val=$00 at PC=$A3B9
- SDCARD: configuring F011 FDC with have_disk=0, can_write=1
- SDCARD: D81: mount register request @ $D68B val=$03 at PC=$9AF4
- SDCARD: D81: (re-?)mounting D81 for starting sector $00331800 on the SD-card
- D81: fd 13 has been attached with 3348480 offset, read_only = 1, autoclose = 0
- SDCARD: configuring F011 FDC with have_disk=1, can_write=0
- SDCARD: D81: mounting OK
- ...
Das image liegt unter ~/.local/share/xemu-lgb/mega65