So, I tried it, but LED blinks not.
Also, when I turn on computer and after IEC-ATA, disk access is always locked, so, I can't load anything.
Where can be mistake?
Du bist in Begriff, Forum64 zu verlassen, um auf die folgende Adresse weitergeleitet zu werden:
Bitte beachte, dass wir für den Inhalt der Zielseite nicht verantwortlich sind und unsere Datenschutzbestimmungen dort keine Anwendung finden.
letzter Beitrag von MIRKOSOFT am
So, I tried it, but LED blinks not.
Also, when I turn on computer and after IEC-ATA, disk access is always locked, so, I can't load anything.
Where can be mistake?
My problem is that every jumper config makes serial port locked if I connect IEC-ATA to computer and power...
I'll try to re-flash it again tomorrow.
Please write to me jumper config at flashing - first are every jumpers free. When starts dialog to confirm flashing, how they have to be configured: JC & RESET...
Thank you very much.
Miro
Yeah, do we really need a new thread for each new problem you encounter?
@mod: Können wir die verschiedenen Threads zum Thema IECATA von ihm zusammenlegen? Man verliert echt den Überblick inzwischen.
All Threads (exclusive one) are now in one...
@Mikrosoft: Please don't open a new thread when the new problem is caused by the solution of the old problem or the nearly the same situation...
so long FighterXXS
the moderating pirate(;
I will never again create new thread, if is it not important...
Thanks for this "collection".
Miro
As much as I understand IEC-ATA locks the bus, even when JR is closed. Is this correct? Please connect IEC-ATA (with or without HD), connect the power-supply, close JR and type 'load"$",10'. Does this really hang (Y/N)?
Test your serial cable: Connect the cable to the C128 (without IEC-ATA) and type 'load"$",10'. Does this hang (Y/N)?
Does your power-supply make exactly 5V? Can you test the voltage of the power-supply?
Background: When you close JR then there is a permanence-hardware-reset of the AVR. All 35 I/O-pins are made input, so the inputs of the outputdriverers (7407 and 74LS07) go to +5V (tested five minutes ago), so they don't make any action to the lines of the IEC-bus, so it is impossible that they lock the bus. At a permanence-hardware-reset it doesn't matter whether there is any (correct) firmware in the AVR. So if this really locks the bus there must be any different defective thing.
Hi!
If I connect IEC-ATA to Serial port, all accessing operations hangs...
So, I tried only one thing what I could:
1. I turn on the computer (C128DCR)
2. Switch to C64 mode
3. Load from drive #8 (internal) NLQ flashing program and run it
4. Loaded selected file to flash
5. Set jumpers to positions as instructions on screen were written
6. NOW - I CONNECTED IEC-ATA - to serial cable and power supply
7. Message was that "problems with AVR..." (I wrote about this longer time ago)
8. So, I select TRY AGAIN - and here's message that Serial Port is locked (look at screenshot)
What to do to make drive access free?
Thanks for every reply.
Miro