I am using m65.exe tool to send PRG to Mega65 but when program LOADS and runs a get DEVICE NOT PRESENT ERROR
When I try the same procedure with GUI tool program loads just fine and without any errors. Why is this happening? I think this Error has to do something with PRG file size.
Hmmm, that's strange since the GUI programm is just graphical frontend for the m65 itself.
Did you try to use the m65 version that is packed in the m65connect frontend ?
I just found solution. I was using the m65.exe tool from m65connect frontend. After you said that it is same code behind booth programs I played little more with GUI tool and noticed that when I use LOAD 8 without 1 parameter I get same error. So than I put -1 to m65.exe and now it works. Apparently without 1 it was missing part of code prom $1000 to $2001 that I am using in program and that was causing error.
Thank you for hint.
Thanks for reporting back !
